SINO SDS 2-3VA, Operation Manual

Page: 16 / 53

11
2.12 Setting the Angle Display Range
In order for the operator to meet the rotation axis’ display requirement,
a parameter of angle display range is set hereby specially, which can be
modified by the operator as required.
Angle range:
1) 0 – 360: The angle display value is between 0 – 360 degrees.
2) -360 – 360: The angle display value is between -360 – 360 degrees.
3) -180 – 180: The angle display value is between -180 – 180 degrees.
Factory default: 0
～
360
For example: Set the angle range
to -180 – 180.
1) On the interface of system
parameter setting,
Press the or key until
the cursor moves to
to the option field of angle range.
2) Press the “+” or “-” function key to switch the angle range to -180 –
180.
3) Press the “Save” function key to save the modification.
4) Press the “Exit” function key to quit the interface of system parameter
setting.
2.13 Setting the Number Setting Direction for the
ZER Coordinate System
In the ZER coordinate system, there are two two number setting modes:
Mode 0: normal number setting mode, in which the displayed value is
equal to the entered value.
Mode 1: special number setting mode, in which the displayed value is
equal to the opposite number of the entered number. This mode
is suitable for directly following the drawing to mark the
dimension presetting coordinate in the ZER coordinate system.
Factory default: 0
For example: Set the ZERDIR on axis X to 1.