![Sinapsi EQUOBOX User Manual Download Page 10](http://html1.mh-extra.com/html/sinapsi/equobox/equobox_user-manual_1279680010.webp)
E Q U O B O X R T U - M o d B u s
–
U s e r G u i d e R e v . 2 . 2
S I N A P S I S . r . l . |
V i a d e l l e Q u e r c e 1 1 / 1 3 - 0 6 0 8 3 B A S T I A U M B R A ( P G )
–
I t a l y
T . + 3 9
0 7 5 8 0 1 1 6 0 4
- F . + 3 9
0 7 5 8 0 1 4 6 0 2 |
w w w . s i n a p s i t e c h . i t
i n f o @ s i n a p s i t e c h . i t
10
•
IP address:
192.168.1.XXX (With XXX being a number ranging between 1 and 254 and different
than 110)
•
Netmask:
255.255.255.0
•
IP allocation:
Static
•
To change the IP address of the computer network adapter, refer to the user manual of the Operating
System of your PC
•
In the event that the PC and the RTU are connected via an existing LAN (company or domestic
network), make sure not to allocate the IP address of the RTU or of the PC
•
For instructions on how to change the IP address of your PC, refer to your current OS
5.4
Connection to a GPRS-UMTS modem/router
A data connection to access the Internet ensures remote consultation of the webserver, sending of
consumption reports, and monitoring of the system. Should a LAN/ADSL connection not be available, you must
use a modem/router supplied as an option of the RTU.
The default settings of the RTU and SIN.ROUTER allow the connection of the two devices without having to
change their network parameters. The router is configured to use a TIM (Telecom Italia Mobile) SIM. In this
case, the user must carry out the following operations:
•
Power off the router.
•
Remove the front panel where the place to insert the SIM is indicated
•
Ensure that the SIM PIN is disabled
•
Insert the data SIM in the right direction
•
Close the front panel
•
Fasten the two GSM MAIN and AUX antennas to ensure sufficient transmission signal
•
Wait for the router to connect to the mobile network
•
Use a network cable to connect port LAN1 of the router to port ETH1 or ETH2 of the RTU
•
Verify that the Internet connection is OK from the display (section RTU INFO, Chapter 8.3)
Should a TIM SIM not be available, the operator will have to change some router settings:
•
Verify whether it is a Machine-To-Machine (M2M) SIM
•
It is enabled for GPRS/UMTS traffic
•
Check with the operator that it is bidirectional. i.e. that it allows access to port 80 for webserver
consultation
•
Change the APN of the router with the one provided by the operator (e.g. ibox.tim.it /
m2mbis.vodafone.it)
Refer to the Appendix (Chapter 20) for in-detail information on router settings.