Simu DIGICODE HZ 2C, Installation Manual

Page: 27 / 228

DIGICODE HZ 2C
Copyright
©
2022 SIMU SAS. All rights reserved.
27
Use
Activating the keypad
The keypad can be activated using:
•
the master code to activate both control buttons.
•
a secondary code to activate one control button.
Once the code is confirmed, the keypad is active for 30 seconds.
Each press restarts the 30-second time delay before locking the keypad.
Control of an automatic function
The code keypad is operated in the same way as the remote controls.
Pressing the same control button several times will lead to the following sequential operations of the motor: Open, Stop, Close,
Stop, Open, etc.
For gate or garage door motors equipped with full or partial opening functions, each control button (if programmed) controls full
or partial opening on separate buttons.
1. Enter a valid code.
2. Press the control button for the motor to
be activated.
ð The indicator light corresponding to
the button comes on then goes out.
ð If the indicator light corresponding to
the button flashes, the code entered
is invalid.
1
2