Simtronics GD1 MK3, Operating Manual

Page: 22 / 76

GD1 Page 22 of 76 850-816926-EN R06
3
Loosen screws 2 and 3 on both the TX and RX.
Important: Nut A and nut on bolt B are
tightened correctly in the factory and should
not be touched. If tightened too much, they
may jeopardize the correct operation of
adjustment screws.
4
Rotate horizontally by hand so the RX and TX
points towards each other.
5
Adjust the RX with screws 4 (vertical direction)
and horizontal by hand until the laser spot hits
the target plate on the TX.
Tighten screws 2 and 3 fully on RX so it cannot
be moved by hand anymore.
6
Swap sides Alignment Laser and Laser Target
Plate so Alignment Laser now is attached to
the
TX side.
7
Now adjust the TX with screws 4 (vertical
direction) and horizontal by hand until the
laser spot hits the target plate on the RX.
Tighten screws 2 and 3 fully on TX so it cannot
be moved by hand anymore.
8
Keep the Alignment Laser and Laser Target
Plate in place to assist in the Fine tuning
procedure.
Coarse alignment finished!
A
B