Simrad SX90 - DATASHEET FOR NAVAL AND COAST GUARD REV A, Quick Start Manual

Page: 35 / 76

386619/C
33
or:
Place the cursor on the button. Press and hold the left mouse button. Move the cursor
horizontally over the button. Release the mouse button when requested value is shown.
or:
Select the middle of the button to open it. If you have a keyboard connected to the
SX90, you can type the requested value.
6 Open the button and select
Apply to all
if you wish to use the chosen setting in all the
views in the current presentation mode.
Related topics
Starting normal operation, page 18
Adjusting the horizontal direction of the sonar beam
The Horizontal view in the SX90 presentation covers the entire 360° omnidirectional sector
For the other views you must define the horizontal direction of the beam.
Context
In the Horizontal view the current bearing is shown with a continuous line pointing out
from the vessel position. The area covered by the vertical beam is shown as a triangle in
the
Horizontal
view.
Note
The choice you make is by default only applied to the currently selected (active) view. The
active view is identified with a thicker border.
A new tracked object is automatically given priority status. The priority is identified with a
"P". The bearing and tilt settings are automatically adjusted to follow the movements of the
tracked target. The bearing line is automatically locked on the object to reflects its bearing.
Procedure
1 Click in the view you want to activate.
The active view is identified with a thicker border. Unless you use the
Apply to all
function, all changes you make will only be applied to this view.
Getting started