| 1
LiveSight | Quick Guide
LiveSight
Quick Guide
About this document
This document describes the main features and setup of the LiveSight transducer.
As the transducer can be used with different display units, this document may not
cover product specific key references. Use your display unit’s documentation in
addition to this quick guide to fully understand how to use and adjust the LiveSight
image.
Installation
Mounting
The LiveSight transducer can be mounted in a front facing or in a down-facing
position. The mounting decides the operational mode.
•
Forward looking mode
Mounted to the trolling motor
shaft
•
Down looking mode
Mounted to the transom, below
the trolling motor or thru-hull
mounted
Offset angle adjustment, forward looking mounted transducers
The brackets only allow the transducer to be mounted at one set angle to the
trolling motor arm.
The best mounting angle for the transducer is obtained when the trolling motor arm
is perpendicular to the waterline. If the trolling motor arm is not perpendicular to
the waterline, the offset angle option in the LiveSight Installation dialog can be used
to fine-tune the transducer angle.
Refer to your system’s installation manual for information about how to access the
settings dialogs.
EN