Simrad ES333-7CD - REV A, Installation Manual, Page: 18 / 32

Simrad ES333-7CD
• Internal threads can be produced with
Emuge
taps, cold
forming taps or thread mills
• Larger thread hole diameters, i.e. increased tool life for
threading tools
• Larger tolerances for thread hole diameters
Drawing standard
Whenever self-locking threads are required, this is shown on
the technical drawing. In the case of tapping through holes,
the arrow at the end of the center line illustrates the screw-in
direction of the bolt.
Figure 6 Drawing examples, self-locking thread
M8 SL*
M10 SL*
(CD017020A)
The drawing is normally provided with the following text (or
similar):
Note: The self-lock threads marked with SL* must be made in
accordance with procedure 842–202125. Drill diameters for
threads differ from standard. Self-lock taps can be supplied by
Simrad.
Taps
The pretension locking thread self–lock (taps) from manufacturer
Emuge
must be used.
16
329787/A