Simrad ES333-7C - REV A, Installation Manual, Page: 29 / 52

Transducer cable glands and splicing
Cable gland for wooden and GRP hulls
A bronze cable gland kit is available for wooden and GRP
vessels.
(CD17008B)
A
B
B
B
C
C
C
D
E
F
A Packing nipple. Make sure that you do not damage the
transducer cable by tightening the packing nipple too hard!
B Washers
C Rubber gaskets
D Hole diameter 28 mm
E Steel conduit
F
Cable to the echo sounder (or a junction box)
The cable gland kit includes all of the necessary parts needed to
install the unit except screws.
Simrad recommends that a one inch steel conduit (that the
transducer cable will be run through) with an inside threaded
diameter of three-quarter inches is attached to the gland’s packing
nipple. This connection must be watertight, and the conduit must
extend to above the vessel’s water line.
329786/A
27