Simrad ES120-7C - REV D, Installation Manual, Page: 51 / 98

330254/B
49
12-pin Amphenol plug
The transducer socket on the transceiver allows you to connect one or more single or split
beam transducers using a 12-pin Amphenol plug (97-24-19P).
In order to connect the transducer cable to the plug, the plug must be disassembled as
described below.
A
Disassemble the plug.
B
Remove a few
millimeters of the
insulation on the
individual cables.
C
Fold the outer and inner
screen backwards, and
fasten them temporary
with tape.
D
Thread each
wire through a
heat-shrinkable tubing,
solder the wire end
to the appropriate pin,
and insulate with the
heat-shrinkable tubing.
E
Remove the tape from
the outer and inner
screen, and spread the
screens out to place
them between the large
washers.
F
Assemble the plug
house, and tighten the
rubber sleeve.
Related topics
Splicing the transducer
cable, page 39
Installing the transducer cable, page 30
Connecting the transducer cable to the transceiver, page 42
ES120-7C Connecting to a 12-pin Amphenol socket, page 46
Splicing the cable using a grounded junction box, page 40
Splicing the cable using a junction box isolated from vessel’s ground, page 40
Cable layout and interconnections