Simrad ES 18 - DATASHEET REV C, Installation Manual

Page: 44 / 88

42
404770/B
12-pin Amphenol plug
The transducer socket on the transceiver allows you to connect one or more single or
split beam transducers using a 12-pin Amphenol plug (97-24-19P).
In order to connect the transducer cable to the plug, the plug must be disassembled
as described below.
A
Disassemble the
plug.
B
Remove a few
millimeters of the
insulation on the
individual cables.
C Fold the outer
and inner screen
backwards, and
fasten them
temporary with tape.
D
Thread each
wire through a
heat-shrinkable
tubing, solder the
wire end to the
appropriate pin,
and insulate with
the heat-shrinkable
tubing.
E
Remove the tape
from the outer and
inner screen, and
spread the screens
out to place them
between the large
washers.
F
Assemble the plug
house, and tighten the rubber sleeve.
Related topics
Cable layout and interconnections, page 37
Simrad ES18 Installation Manual