Simrad ES 18 - DATASHEET REV C, Installation Manual

Page: 35 / 88

404770/B
33
Mounting the transducer
When all the preparations have been made, the transducer is mounted. If required,
additional and more detailed procedures must be provided by the installation ship yard.
Prerequisites
The following requirements
must be met before mounting the
transducer:
• The physical location of
the transducer has been
determined.
• The mounting ring has been
installed.
• The steel conduit is mounted
with all installation work
finalized.
Note
Whenever relevant, all drawings
as well as the physical installation
of each device must be approved
by the vessel’s national registry
and corresponding maritime
authority and/or classification
society.
The following special tools are
required for this installation:
• Torque wrench
• Loctite 270 (permanent high-strength threadlocker)
• Lifting device
Illustration:
A
Mounting ring
B
Clamping ring
C Cable service loop
D
Bolt
Installing the transducer