Bladder Connector
Eject
®
Insertion Tool
Eject
®
CO2
Cartridge
Eject
®
CO2 Infl ator
Eject
®
Bulb
Infl ator
Eject
®
Bladder
Eject
®
Practice Bladder
EMS/First Responder
Helmet Removal System
Instructions and Safety Information
See reverse side of this sheet for
EMS helmet removal instructions.
To Prepare the CO2 Infl ator:
Use only Simpson Eject 16g non-threaded
CO2 cartridges, other cartridges may not fi t
properly.
Make sure the red safety lever is in the down
position.
1.
Unscrew infl ator head from cartridge cup.
2.
Shake cartridge.
3.
Insert a NON-THREADED CO2 cartridge
into the cup so the narrow end faces up.
Thread infl ator head onto the cup, turning in
until the cartridge just contacts the puncture
pin, then quickly and fi rmly twist to puncture
(activate) and seal the CO2 cartridge.
Infl ator is now charged and ready for use.
Eject
®
Helmet Removal System
CO2 Infl ator and Cartridge Operating Instructions:
Figure A.
Step 1.
Step 2.
Step 3.
Do not inhale CO2 gas. Do not
discharge CO2 gas towards face,
body, or people. CO2 gas becomes
extremely cold when dispensed and
should not be exposed to bare skin
as frostbite may occur.
• DO NOT modify the Eject
®
Helmet
Removal System in any way.
Modifi cations may affect the
proper function.
• Never use any device not approved
by Simpson for infl ation. This
can result in injury to the rider/driver.
WARNING:
You must completely understand
all Eject
®
Helmet Removal System User
Instructions and safety information before
using this product.
Safety Lock Feature:
Do not activate a CO2 cartridge until ready
to use.
Move the red safety lever to the “up” position to
lock the dispensing trigger. (Figure A.) To unlock
the dispensing trigger, move the red safety lever
into the “down” position.
CO2 can ONLY be dispensed when the safety
lock is in the unlocked “down” position.
All CO2 gas must be expelled from used
cartridge before replacement of CO2 cartridge.
Use a new cartridge each time you infl ate an
Eject
®
unit.
Package may contain any of the following:
Contact Eject
®
Customer Support
at 1-800-654-7223 or email us at
[email protected] for
more information, training materials
or technical questions.
IMPORTANT
SAFETY INFORMATION
• These instructions are for
Emergency Medical Services (EMS)
to follow when responding
to an accident.
• Simpson recommends that the
Eject
®
Helmet Removal System be
used ONLY by rescue personnel
trained in spine immobilization
who have complete training on
the system and have read the
full instructions. Proper training
includes practicing before using the
Eject
®
System on an accident site.
Figure B.
DO NOT infl ate the Eject
®
system
if there is structural damage to the
top of the helmet.
Determine whether Eject
®
is
installed in the rider/driver’s
helmet.
Look for “Eject
®
Equipped” helmet sticker
and connector protruding from base of
helmet. (Figure B.)
This should be located on the left side of
the helmet. Check the inside chin bar area
for sticker if rider/driver is positioned such
that the left side is covered.
