Simpro Multi-Tip MT1200, User Manual

Page: 30 / 48

3.8.3 Annual inspection
The following inspection should be carried out every 12 months, and the results recorded in
the log on the following page.
Annual Inspection Checklist
Category No. Item Check
General 1 Entire machine
Visually inspect for dented or broken parts.
Carry out a complete tipping cycle, watching for
any faults or abnormal behaviour.
Hydraulic
systems
2 Hydraulic Ram Inspect for oil leaks.
3 Oil Reservoir
Drain and replace hydraulic fluid, as per
specifications in
§3.7.4 . Clean intake suction-filter.
4
Lowering Valve
Remove and clean.
Electrical
systems
5
Charging Lead
Both plugs are good condition, no frayed or
damaged insulation.
Safety
systems
6
Dual-hand
controls Dual-hand controls are working correctly – machine
stops instantly when SAFETY button is released.
7
Safety labels and
markings All warnings labels, operation guides etc are
attached and legible.
Mechanical
systems
8 Mast and cradle
Not twisted or damaged.
No cracked or broken welds.
9 Inside of mast
Lightly lubricate with silicone spray. 10
Follower Roller
11 Cradle Axle
12
Tipping Guide
Flap
Flap is undamaged and moving freely.
13 Castor Wheels
All castors
running smoothly and both brakes working correctly.
Cartridge 0250090055
24V Coil 0250090067
UK 0790050103
NZ/AU 0790050218
0090120000
0230040001
Unbraked 0250040087 Braked 0250040090