FEATURES
A portable jump starter with a 12V battery that is ideal for any jump
starting need
s and can be used on boats, cars, trucks, tractors, generators
and is fully compatible with any 12 volt starting system. It also has
a built
in air compressor and
a 15 LED
work
light
.
The jump starter
utilizes a
MAINTENANCE FREE SEALED BATTERY which allows the unit to be
stored without fear of leakage. The jump starter can be conveniently
store
d
under or behind a seat.
I
nclude
d are
2 air valves, 1 sports needle,
1 12V car cigarette plug
and
1
AC/DC charging
adapter.
SPECIFICATIONS
1. Output voltage: 12VDC
2.
Power output:
3
00AMPS start; app.
7
00AMPS peak
3. Output from cigarette lighter socket: 12VDC<15AMPS
4. Charging: 12VDC/500mA
5. Internal battery status: LED indicator
6. Safety switch
7.
250 PSi
air compressor
OPERATIONAL INSTRUCTIONS
1.JUMP STARTING:
1.
Switch the engine of the vehicle or boat to be jump
started to OFF.
2. Connect the RED clamp to positive post(+) of battery, then the BLACK
clamp to negative post(-) of battery.
CHECK THE 'POLARITY' LED IS
GREEN BEFORE PROCEEDING; IF RED DO NOT TURN UNIT ON!
3.
Turn safety switch
on Jump Starter
to "I" position.
4. Switch the vehicle or boat ignition to "ON".
5. Wait a minute or two.
6. Switch the vehicle or boat engine ignition to "START" for no more than
5 to 6 seconds.
7. If the vehicle or boat engine does not start, wait a least 3 minutes before
trying again.
8.
Once the vehicle or boat engine is running
,
safely switch to "O"
pos
i
ton. disconnect the clamps and restore them to their storage
position.
C
harging the Unit
Plug the adaptor into a mains power supply and the charging
connector into the 'charging' socket on the front panel of the unit.
When the red "charging" LED illuminates, the unit is then charging.
When charged the green LED will illuminate. The battery may require a
charge of 8-20hours. The charge cord should be disconnected once
the battery is fully charged.
For
safe and correct use
, when using to jump
start a
vehicle or
boat please read and follow these step-by-step instructions:
8.
15 s
uper bright white LED
light
9. 5V USB port
CHECK BATTERY
Press the "TEST"
button to
check the
status
of
the internal
battery
.
When the yellow LED
comes
on, the bat
t
ery
should
be
charge
d
.
Green
LED
- Good charge
Yellow
LED
-
Weak/Reacharge
(Jump start may not be possible at this battery level)
Red
LED
- Recharge
ATTENTION
1.
Do not use the battery if the cable or plug is damaged.
2. Repairs should be carried out by experts only. Otherwise it may cause
considerable danger for user.
3. Avoid short circuit of the product:
D
o not
touch the poles
with
any conductive material.
Do
not
store the battery in a box in which the poles might
touch
other objects.
4. To avoid damage of cable or plug, never pull the cable to disconnect
the charger.
5. Keep this product out of reach of children.
6.
Do
not
store in places
where
the temperature could
exceed 50 C.
7.
Do
not
exp
o
se this product to water or moisture.
8. This unit has a sealed lead-acid battery that should be kept at full
charge. Recharge when first received
and
immediately after each
use.
Recharge the battery if not used for 90 days
as
failure to do
this may
cause the battery life to be reduced.
9. Always wear glove and eye protection when working on or around
lead-acid batteries.
2
.LIGHT & USB
Press the "LIGHT"
button to turn on the light, and again to turn off.
Press the "USB"
button to turn on the USB port so
you can charge
your
device at 5V.
3
.COMPRESSOR OPERATION
Caution:
Run compressor for a maximum of 10mins at a time.
After this
leave for 10 minutes before using again so that
the
compressor can cool.
1.Be sure main power switch on front face is in the ON position.
2.
For
tyre
inflation use the universal adapter that is attached permanently
to the air hose.Place this adapter onto the t
y
re valve system.Press
the adapter lever down to lock onto the valve system.
3.
For inflating leather balls,floation devices, etc.,use one of the plastic
nozzles.
4. Check pressure gauge, determine the desired pressure.
5.
Turn on
air compressor with the
switch
on the rear of the unit
.
6. When the desired pressure is reached turn the compressor switch off.
7.
Remove the adapter from
tyre
or other item being inflated.
C
M
Y
CM
MY
CY
CMY
K
SJS15 MANUAL.pdf 1 11/03/2019 09:45:48
8
.
Turn main power switch OFF to prevent battery drain
.
4
IN
1 JUMP
START
ER
12V
/
1
5
AH Battery
INSTRUCTION MANUAL
o
®
®
Part of Simply Brands simply-brands.com