12V Oil PumP
Part
no
:
OTP01
Thank you for purchasing a S
imply
product. manufactured to a high standard, this product will, if used according to
these instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SafeTy
9
Maintain the pump in good condition (use an authorised service agent).
9
Replace or repair damaged parts. Use recommended parts only. non authorised parts may be dangerous and will invalidate the
warranty.
9
Keep the pump clean for best and safest performance.
9
Familiarize yourself with the applications, limitations and potential hazards of the Transfer Pump.
9
ensure the power supply (vehicle battery) corresponds with the requirements of the pump.
9
ensure that there is more liquid in the delivery tank than will be needed.
9
ensure that the capacity of the receiving tank is sufficient to hold the dispensed fuel.
9
Wear safety goggles and gloves, and protective clothing when working around fuel. A full range of personal safety equipment is
available from your local Sealey Stockist.
9
Keep area clean and tidy and free from unrelated materials, and ensure there is adequate lighting.
9
Maintain correct balance and footing. ensure the floor is not slippery and wear non slip shoes.
9
Use the pump in an appropriate working area for its function. Keep area clean and tidy and free from unrelated materials.
9
Keep children and unauthorised persons away from the working area.
8
DO NOT
run the pump dry. This will damage the pump’s internal components and will invalidate your warranty.
8
DO NOT
operate the pump continuously for more than 30 minutes. The duty cycle of the unit is 30 minutes, after which the motor must
be left to cool down for 30 minutes.
8
DO NOT
run the unit for more than 2-3 minutes with the delivery nozzle closed.
8
DO NOT
start or stop the pump by connecting or disconnecting the battery clamps.
8
DO NOT
operate the pump with wet hands.
8
DO NOT
use the pump where explosive or flammable vapours may be present.
8
DO NOT
tamper with the pump connections.
8
DO NOT
pull or carry the unit by its cables and do not pull the negative and positive clamps from the battery terminals.
8
WaRNiNG! DO NOT
use the unit to pump the following fluids: Petrol, flammable liquids with flash point <38°C, water, foodstuffs,
corrosive chemicals and solvents.
8
DO NOT
smoke or allow a spark, or flame in the
vicinity of the battery or pump.
WaRNiNG! DO NOT
use the unit to pump the following fluids:
Petrol, flammable liquids with PM <55°C, water, alimentary liquids with viscosity >20 cSt., corrosive chemicals and solvents.
WaRNiNG!
The warnings, cautions and instructions referred to in this manual cannot cover all possible conditions and situations
that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must
be applied by the operator.
2. iNTRODucTiON
Robust and compact portable pump ideal for extracting engine oil or diesel. Powered from a 12V battery. Supplied with a 1.2mtr suction hose,
2mtr discharge hose and a 2mtr battery cable with clips. not suitable for use with Petrol.
3. SPecificaTiON
Model no: ..................................................................
OTP01
Current: ..............................................................................7A
duty Cycle: .................................................................. 30min
Flow Rate: ..................
......................
Diesel approx.
1.
5
ltr/min
or engine oil (maximum 60
°C
) approx.
0.2ltr/min
nett Weight: ................................................................ 0.95kg
Power: .............................................................................84W
Voltage: ............................................................................12V
OTP01
Issue 1
11
/0
3
/
20
©
JRP Distribution Ltd
Refer to
instructions
fig.1
Wear eye
protection
Wear protective
gloves
Warning