Mechanically installing the 2-Stage Station
After all electrical connections have been made, install the 2-Stage Station IAM into a electrical box (not
supplied) behind the Manual Station using Figure 4 as a reference. Refer to the 2099-Series Non-Coded
Fire Alarm Stations Installation and Operating Instructions (574-656) for information on other mounting
configurations. Mount the 2-Stage Station IAM to the electrical box as follows:
For surface mounting, use a 2975-9178 red steel back box or a 2975-9022 aluminum back box. Do not
substitute a box with a depth less than 2-3/16 inches (5.55 centimeters).
For semi-flush mounting, use a standard 4-inch (10.16 centimeters) square back box with a minimum depth
of 2-1/8 inches (5.39 centimeters). Fit the back box with a 3/4 inch (1.9 centimeters) deep single gang
switch cover set flush (DO NOT RECESS) or protruding 1/16 inch (.16 centimeter) from the wall surface.
1. Install the 2-Stage Station IAM inside the electrical box in a position that allows the manual station
adequate room to be mounted onto the electrical box. The attached field wiring holds the 2-Stage
Station IAM in place inside the electrical box.
2. Secure the manual station to the back box.
Figure 4. 2-Stage Station IAM Back Box Installation
4099-9801C IDNet
2-Stage Station
IAM
Installation Instructions
574-179
Rev. D
574-179
Rev. D
2000 Simplex Time Recorder Co., Westminster, MA 01441-0001 USA
2000 Simplex International Time Equipment Co., Ltd., Mississauga, Ontario L4V 1H3 Canada.
All specifications and other information shown were current as of publication, and are subject to change without notice.
IDNet
is a trademark of Simplex Time Recorder Company.
Suffix “C” following an 8-digit Product ID number denotes ULC-listed product
.
IAM Assembly
Label
DIP Switch
(Under Re-sealable Label)
Terminal
Front View
Rear View
LED
Note:
The LED flashes approximately once every three
seconds to indicate valid communications with the FACP.
Cautions and Warnings
DO NOT INSTALL ANY SIMPLEX PRODUCT THAT APPEARS DAMAGED.
Upon unpacking
your Simplex product, inspect the contents of the carton for shipping damage. If damage is apparent,
immediately file a claim with the carrier and notify Simplex.
ELECTRICAL HAZARD
-
Disconnect electrical power when making any internal adjustments or repairs.
Servicing should be performed by qualified Simplex Representatives.
STATIC HAZARD -
Static electricity can damage components. Ground yourself before opening or
installing components.
Introduction
The 4099-9801C 2-Stage Station Individual Addressable Module (IAM) provides addressability to
pre-signal type hardwired stations. The four device states (NORMAL, OPEN, CURRENT-LIMITED
and SHORT) are communicated to the 4010 Fire Alarm Control Panel (FACP) via the IDNet
channel.
Contacts for both General Alarm and Pre-Signal Alarm are supervised by the IAM. The IDNet channel
provides the communication link between the IAM and the 4010 FACP and powers the entire IAM circuitry.
Installation
2-Stage Station IAM installation consists of
the following:
•
Setting the 2-Stage Station IAMs address
•
Making electrical connections to the 2-Stage
Station IAM and to the IDNet channel
•
Mechanically installing the 2-Stage Station IAM
Figure 1. 2-Stage Station IAM
Installation
firealarmresources.com
