The drawing appearing on this page is not a warranty,
and may be subject to change or modification without any prior notice.
Rev. 1.0 1/2page
Installation
20001
LS Simple
™ Cabling Solution
Enhanced Rear IDC Modular Jack
1. Prepare the Easy Termination with ERI
Modular Jack.
1
Door Type
Non door Type
2. Place the wires into the slots according
to the wire scheme.
2
3. Put the Keystone Jack onto the
Easy Tool in the right position and
then squeeze the tool then terminate
all wires and trim the excess wires at
the same time.
3
4
4. Remove the Keystone Jack
vertically away from the termination
tool.
