Assembly instructions for kit #12
1
This is not a Lego® product even if it contains Lego® bricks and plates. All warranties provided by Simple Motors.
LEGO® is a trademark of the LEGO Group of companies which does not sponsor, authorize or endorse this product.
All rights reserved. 2014 Simple Motors, LLC
♦
www.simplemotor.com
♦
Assembly Instructions: Kit #12
Rapid Assembly Basic QuikLock
Reed Switch Motor
1. Insert the motor shaft through the holes in two 2x2 rotor pieces as shown*. Center the
shaft.
2. Add plastic sleeves (washers) to both ends of the shaft. They fit tightly and require some
effort. You may put the sleeve on the table and push the shaft in with the negative end of
the battery. Leave a small gap so the sleeves are slightly above the surface of the knobs.
