SimonsVoss SI:SmartHandle Series, Manual, Page: 98 / 160


1 x inside fitting adapter plate

1 x outer handle, including handle fastener piece

1 x inside handle, including hexagon socket screw

4 x long mounting screws

5 x short screws (8 x for DP version)

1 x quick start guide

1 x installation tool for inlay

1 x drilling protection plate (for DP version only)
8.9.2 Tools required
The following tools are required for installing SI:SmartHandle and are not
included in the supplied package:

Allen key (3 mm) to fit handle

Spanner (19 mm)

Cross-tip screwdriver type PH2

Hack saw (to cut fastening screws to length)
8.9.3 Installation instructions

Batteries are already installed when the product is delivered!

When installing the electronic SI:SmartHandle, ensure that there are no
sources of low-frequency interference in the surrounding area.

SI:SmartHandle must be fitted, so that it is flush with the door. You
must install the product as specified to ensure that it is structurally
stable and will have a long service life.

You must not strike parts of SI:SmartHandle during installation.

The two inlays in the cover are locked into position with a clip
mechanism. These may only be removed using the SimonsVoss
installation tool.

No water or moisture must penetrate the door or reach the inner side.
Always use the WP version for moisture.

Programme SI:SmartHandle before installing.

SI:SmartHandle may be difficult to fit in mortise locks with a retaining
nut. You must not alter the retaining nut in any way, using a file, for
example; otherwise, the handle's guide piece will no longer fit
accurately.

When installing SmartHandle, you must ensure that the cable does not
get caught or fitted too tightly to the door.
SmartHandle SmartIntego (Manual)
8. Installation (manual)
98 / 160