SimonsVoss SI:SmartHandle Series, Manual

Page: 70 / 160

8.4.7 Restore storage mode for conventional fastening system MO
1. Disconnect the 3-pole cable from the inside fitting with the 3-pole cable
from the outer fitting. If necessary, also disconnect the LockNode cable
from the inside fitting.
2. Hold the inside and outer fittings firmly while pulling them away from
one another horizontally.
Fitted to the door:
NOTE
General instructions: Depending on the handle model, it may not be pos-
sible to remove the inlay immediately. In such a case, push the inlay
through the opening in the cover and remove the cover. The inlay remains
on the handle and cannot be removed until the handle is dismounted.
Follow the same steps as for installation but in reverse order.
8.5 Conventional fastening ES1/SKG/PAS24
8.5.1 Contents of packaging

2 x inlays

2 x covers

1 x outer fitting

1 x inside fitting

1 x outer handle (including lock ring)

1 x inside handle (including hexagon screw)

3 x sleeves

3x fastening screws "long"

1 x adapter plate for inside fitting

1 x adapter plate for outer fitting

1 x spacer plate for outer fitting

6 x fastening screws "short"

1 x quick start guide

1 x installation tool for inlay

1 x Installation tool for four-wire cable

1 x drilling template
SmartHandle SmartIntego (Manual)
8. Installation (manual)
70 / 160