SimonsVoss SI:SmartHandle Series, Manual, Page: 153 / 160

16.3 Restore storage mode for conventional fastening system MO
1. Disconnect the 3-pole cable from the inside fitting with the 3-pole cable
from the outer fitting. If necessary, also disconnect the LockNode cable
from the inside fitting.
2. Hold the inside and outer fittings firmly while pulling them away from
one another horizontally.
Fitted to the door:
NOTE
General instructions: Depending on the handle model, it may not be pos-
sible to remove the inlay immediately. In such a case, push the inlay
through the opening in the cover and remove the cover. The inlay remains
on the handle and cannot be removed until the handle is dismounted.
Follow the same steps as for installation but in reverse order.
16.4 Restore storage mode for SwissRound MO
1. Disconnect the 3-pole cable from the inside fitting to the 3-pole cable
from the outer fitting. If necessary also disconnect the cable of the
LockNode from the inside fitting.
2. Hold the inside and outer fittings firmly while pulling them away from
one another horizontally.
3. If necessary, loosen the hexagon screw in the inside door handle, but
ensure that you only unscrew a little, so that the screw remains in the
handle.
4. Remove the inside handle from the inside fitting.
Fitted to the door:
NOTE
General instructions: Depending on the handle model, it may not be pos-
sible to remove the inlay immediately In such a case, push the inlay through
the opening in the cover and remove the cover. The inlay remains on the
handle and cannot be removed until the handle is dismounted.
Follow the same steps as for installation but in reverse order.
16.5 Restore storage mode for ScandinavianOval
1. Disconnect the 3-pole cable from the inside fitting to the 3-pole cable
from the outer fitting. If necessary also disconnect the cable of the
LockNode from the inside fitting.
SmartHandle SmartIntego (Manual)
16. Disassembly
153 / 160