Internal/external antennas
For SREL.ADV only
Auto-detection
If an external antenna is connected, this is the one which is used.
SmartRelay switches off the internal antenna in such cases. If no
external antenna is connected (standard case), SmartRelay
functions with the internal antenna.
Both active
SmartRelay is able to use both antennas to verify transponder
bookings.
6.1.2 Locking device properties: Configuration/Data: SmartRelay (G2)
This tab is divided into two sides:
The left side shows the target status of the locking device – i.e. the
desired status configured in the LSM software.
The right side shows the locking device's current status – i.e. the status
which was last programmed.
The following features can be enabled
depending on the locking device
type
:
Pulse length
This where you indicate the number of seconds for the duration of
switch pulse. The value can be set at 0.1 to 25.5 seconds. If you enter 3
seconds, for example, an electric strike is released for 3 seconds before
it locks again.
Access control
ZK and ADV possible. The most recent transponder transactions are
logged with the date and time.
Time zone control
Only possible in ZK and ADV versions. A time zone plan can be
uploaded and the transponders are approved or blocked according to
their time zone group.
Logging unauthorised attempted access events
For ZK and ADV only: Normally, only authorised transponder operations
are logged. You need to select this option if you also wish to record
attempts to open the door with non-authorised transponders.
Gateway
SmartRelay can be used as a gateway.
Flip-flop
SREL1+2
(Manual)
6. Configurations in the software
27 / 38
