30.Check that the outer handle (3) can turn easily; if it does not, there may
be a problem with the mortise lock (6) or the handle may have been fit-
ted incorrectly. In case of doubt, disassemble components and start
again from Step 10.
31. Push the cylinder through the designated hole in the fitting from the
outside. In doing so, ensure that the cam is at the six o'clock position
and that the 3-pole cable does not get caught or buckled.
32. Fasten the cylinder with the fastening screw by hand, using about
5-7 Nm – note that cylinder and screw are not part of the supply.
33. Carefully push the 3-pole cable into the outer fitting.
34.Push inlay (14) onto the inside handle (11). Depending on the handle
model, it may not be possible to fit it once the handle is installed.
35.Push inside handle (11) onto the inside fitting (8) fastening flange until it
will go no further.
36.Fasten the hexagon screw (12) on the inside handle (11) firmly by hand.
37. Push the cover (13) over the inside handle (11).
38.Carefully push the inlay (14) through the opening in the inside cover (13).
39.Push cover (13) onto the inside fitting (8), so that it is flush with the
door. The cover is not symmetrical; look carefully at the marking to en-
sure correct positioning (Diagram 7).
40
.
Click the inlay (14) carefully into the cover (13).
41. Press the cover plate (15) for the cylinder body carefully into the open-
ing in the inside cover (13).
42.Push the cover (2) over the outside handle (3).
43.Carefully push the inlay (1) through the opening in the outside cover (2).
44.Push cover (2) onto the outer fitting (4), so that it is flush with the door.
The cover is not symmetrical; look carefully at the marking to ensure
correct positioning (Diagram 7).
45.Click the inlay (1) carefully into the cover (2).
7.8.5 Conventional fastening system, including Swiss Round MO WP
Installation:
1. Optional: handles, escutcheons, fittings and other door furniture fitted
to the door are to be removed.
2. SmartHandle is partly assembled when supplied; see "Disassembly".
SmartHandle
(Manual)
7. Installation (manual)
80 / 136
