7 Installation (manual)
Some variants are supplied screwed into temporary spacer sleeves, so that
the SmartHandles can be programmed in the packaging. This will ensure
that the metal surfaces touch. Contact needs to be established in this way
to programme SmartHandle.
Temporary spacer sleeves are used to secure SmartHandles during
transport and are not needed to operate SmartHandles.
The plastic screws are used to secure SmartHandles during transport
and must not be used for installation.
7.1 Snap-in
7.1.1 Contents of packaging
2 x inlays
2 x covers
1 x outer fitting
1 x inside fitting
1 x outer fitting, including lock ring
1 x inside handle for inside fitting (including hexagon screw)
1 x mounting screw
1 x profile cylinder inlay (in versions for fire retardant doors only)
1 x quick start guide
1 x installation tool for inlay
7.1.2 Tools required
The following tools are required for installing SmartHandle 3062 and are
not included in the supplied package:
Allen key (3 mm) to fit handle
Cross-tip screwdriver type PH2 (battery screwdriver recommended)
7.1.3 Installation instructions SnapIn
Batteries are already installed when the product is delivered!
When installing the electronic SmartHandle 3062, ensure that there are
no sources of low-frequency interference in the surrounding area.
SmartHandle 3062 must be fitted, so that it is flush with the door. You
must install the product as specified to ensure that it is structurally
stable and will have a long service life.
SmartHandle
(Manual)
7. Installation (manual)
29 / 136
