How to re-pair the wireless speaker mic.
Each X10DR Secure Wireless Microphone is uniquely
connected to a specific X-Ponder mobile charger in the
factory. This ensures that all communications between
the two units are secure and cannot be compromised
or interfered with by a third party. In the event of a
Secure Wireless Microphone being lost, it can be
permanently disconnected from the X-Ponder mobile
charger by connecting with a new replacement unit.
How to reconnect:- Hold the speaker mic while
pressing both the blue volume controls until the blue
LED flashes and the speaker mic beeps.(after 8 secs.)
Now place the speaker mic back into the mobile
charger. After a few seconds the speaker mic will sound
a confirmation two tone and the blue LED on both units
will glow solid to indicate connection is complete.
Table 2: How to re-pair the wireless speaker mic.
13.4. AUDIO ADJUSTMENTS
Note:- To be carried out by qualified service personal only.
When installing the MWRSM system you should first carefully adjust the transmit and
receive audio levels via the trim-pots on the bottom of the Charger cradle device.
Transmit and receive audio levels.
TRANSMIT: while listening on another radio,
talk VR1- into the Mobile Mic and adjust VR1
so it sounds the same volume and clarity as
the host mobiles wired microphone.
RECEIVE: Using another radio, talk into its
microphone and ad- just VR2 so that the
audio received through the MWRSM speaker
is loud and clear with the MWRSM Volume
turned up near maxi- mum.
Table 3: Transmit and receive audio levels.
Doc Number:
TNM-U-E-0180 ISSUE 1.1
Page
28
