Simex SRT-94-XA, User Manual

Page: 24 / 44

User manual - METER SRT-94-XA
• If parameter „ AL ” = „ on ”, the relay will be turned on in the critical situations,
even if his parameter
“modE” = ”noAC”.
7.3.2. “bEEP” menu
This menu contains options connected with acoustic signal :
" AL ” - if this parameter is set to “ on ”, any critical situation causes by acoustic signal
"
r1”
- if this parameter is set to “
on
”, activation of relay
R1
causes by acoustic signal
"
r2
" - if this parameter is set to “
on
”, activation of relay
R2
causes by acoustic signal
" r3 " - if this parameter is set to “ on ”, activation of relay R3 causes by acoustic signal
" r4 " - if this parameter is set to “ on ”, activation of relay R4 causes by acoustic signal
Acoustic signal (turned on by e.g. relay ) can be turned off by pressing of any
button
7.3.3. “inPt” menu
This menu presets the measurement input:
“ tYPE " - type of the input / sensor. This parameter can be set to values:
thermocouple type measurement range
” tc K ” -200˚C ÷ +1370˚C
” tc S ” -50 ˚C ÷ +1768˚C
” tc J ”
-210˚C ÷ +1200˚C
” tc t ” -200˚C ÷ +400˚C
” tc n ” -200˚C ÷ +1300˚C
” tc r ”
-50 ˚C ÷ +1768˚C
” tc b ” +250˚C ÷ +1820˚C
” tc E ” -200˚C ÷ +1000˚C
” volt ” The device has additional measurement range (-10÷90mV)
mainly for diagnostics of measurement circuits. Being in
this range, unit displays direct voltage connected to its
input with resolution 0.01mV (without compensation of
cold ends).
”FiLt” - this parameter sets filtration rate. It can be set to values from 0 (no filtration ) to 5
(strongest filtration – time window about 2 sec).
“toFS”
- offset (expressed in 1°C, range ± 99°C.). This parameter allows shifting of
measurement scale, and express value added to calculated (measured) result.
Warning: The offseting of a scale is realised independently of cold ends automatic
compensation.
24
i