Simex MultiCon CMC-N16, User Manual

Page: 154 / 292

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-N16
Fig. 7.84. Two threshold control of the virtual relays
Fig. 7.85. Levels settings for Mode : above and below level (left) and inside range and
outside range (right)
Timing parameter block (see Fig. 7.88 )
The parameters of this block include:
–
ON delay
- this parameter allows to set the time that must pass from the time of
exceeds
Level
value until the output switches from low to high state (see
Fig. 7.86
),
– OFF delay - this parameter allows the user to set the time that must pass from the
time of exceeds Level value until the output switches from high to low state
(see Fig. 7.86 ),
–
Minimum ON time
- the minimum duration of a high state (if the output switches to
high state the low state will occur after this time) - see
Fig. 7.87
,
–
Minimum OFF time
- the minimum duration of a low state (if the output switches to
low state the high state will occur after this time) - see Fig. 7.87 ,
154
zone B zone A
zone B
Lower level Upper level
parameter
Hysteresis parameter
Output
state