Simex MultiCon CMC-99/141, User Manual

Page: 97 / 332

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-99/141
7.8.3. Logical Channels - Hardware output monitor mode
This mode allows the user to display data from the built-in output modules, processed in
any other logical channels (e.g. by a mathematical function or virtual relay) or it can be the
data source for controlling another output.
The configuration view of a Logical channel in the Hardware output monitor mode is
shown in Fig. 7.50 .
The parameters of a Logical channel in the Hardware output monitor mode are:
–
Name
- it gives the name to the logical channel,
– Unit - for Built-in modules it will automatically default to the unit of the module. To
change the unit use the Scaling parameter in the Processing parameter block,
– Mode=Hardware output monitor - in this parameter the user selects the source of
data for the logical channel,
– Source - in this parameter the user selects the source of data from the available
built-in outputs list for the logical channel (see below in this
Chapter
),
–
Latch
parameter block - allows the user to set the
latch function
which will hold the
last value of a channel (discussed in Chapter 7.8.1. Logical Channels - General
settings ),
–
Processing
parameter block - is used for scaling and filtering data (discussed in
Chapter 7.8.1. Logical Channels - General settings
),
– Displaying parameter block - these parameters allow the user to select the format
and range of data displayed on the screen (discussed in Chapter 7.8.1. Logical
Channels - General settings ),
97
disabled
Hardware input
Hardware output monitor
Modbus
Set point value
Math function
Controller
Profile/timer
Profile/timer (cycle counter)
Data from other channel
Logical channel Device configuration MENU
Mode