14
1.3.2
Holiday function
This function allows the user to deactivate both heating and hot
water production during a
“set and activated”
holiday period,
during which the antifreeze function can be active (if set).
To set the holiday function from the
“Main screen”
:
– press the
Mode
button
– press the
click
encoder to confirm one of the
Summer
or
Winter
function mode
– turn the
encoder to select
“Holiday function”
Esc
Back
Winter
Off
Summer
Hot water
MAN 40°C
Heating
MAN 20.0°C
Holiday function OFF
Fig. 22
– press the
click
encoder to confirm the
“Holiday function”
and go into the modifiable area
Cancel
Confirm
HOLIDAY SCHEDULE
Hot water OFF - Heat. OFF (nofrost active)
DAY
MONTH
YEAR
HOUR
Start: 05 02 2014 15 : 00
20 02 2014 15 : 00
Stop:
Enable holiday: NO
Fig. 23
– turn the
encoder to modify the
“Data/value”
which is
highlighted
– press the
click
encoder to confirm the modification and
move to the next
“Data/value”
Cancel
Confirm
HOLIDAY SCHEDULE
Hot water OFF - Heat. OFF (nofrost active)
DAY
MONTH
YEAR
HOUR
Start: 05 02 2014 15 : 00
20 02 2014 15 : 00
Stop:
Enable holiday: NO
Fig. 24
– turn the
encoder to modify the
“Data/value”
on the ba-
sis of the holiday start date
– press the
click
encoder to confirm the modification and
move to the next
“Data/value”
– continue in this way until all the necessary modifications
have been made..
NOTE
: The user must work in a CIRCULAR manner, meaning
ALWAYS MOVING FORWARDS, even if a mistake is made.
– When all modifications have been made, press the
Confirm
button to go back to
“Holiday function”
– press the
Esc
button to go back to the
“Main screen”
.
Th 21 Sept 2014
Zone
10:30
Menu
Mode
Hot water 48°C eco
Winter automatic - set 20.0°C until 7.30
Fig. 25
1.3.3
Fault warnings
If a fault occurs, the screen
“Anomaly in progress”
will appear
in place of the
“Main screen”
. For the main fault codes, a brief
description and suggestions for the user are displayed, based
on the seriousness and the frequency with which the fault re-
appears.
Esc
Reset
ANOMALY IN PROGRESS
6 - No flame detection
Reset boiler
Esc
Back
ANOMALY IN PROGRESS
5 - Technical problem
Contact customer service
Name: xxxxxxxx
Phone:yyyyyyyyy
Fig. 26
The fault may be
transient
(volatile) or it may cause an appli-
ance
block
.
To restore normal operating conditions:
– if the fault is transient, eliminate the cause of the fault
– if the fault causes a block, remove the cause of the fault and
then press the
Reset
button.
If there is
“no water in the system”
or
“low water pressure in the
system”
there is a request to fill the system and then to press
the
Confirm
button rather than the
Reset
button.
Esc
Charge
ANOMALY IN PROGRESS
2 - Low pressure
Fill the system as per boiler's manual instruction
Cancel
Confirm
CONFIRM REQUEST
Confirm operation?
Fig. 27
m
CAUTION
For a full list of faults, see "Malfunction codes and
possible solutions".
