Sima EUROTRON PLUS, Original User Manual, Page: 26 / 50

9
ENGLISH
WARNING: Earthing should always be connected before the launch of the machine.
• Make sure the voltage supply to the network will be connected to the machine; it matches the voltage indicated on
the sticker red voltage display attached to the machine.
• Use extension cords standardised
• Make sure the extension cord to power supply of the machine has not contact points of high temperature, oil, water,
sharp edges, avoid being trampled or crushed by passing vehicles and placing things on it.
7.3 PICTOGRAMS
Pictograms included in the machine entail the following:
8. MACHINE STARTING-UP AND USING INSTRUCTIONS
WARNING: Must follow all safety recommendations outlined in this manual and comply with regulations for
the prevention of occupational hazards.
8.1 POSITION OF THE MACHINE AND THE OPERATOR, CONNECTION AND DISCONNECTION
Before starting-up the machine, we should have gone through all
necessary safety measures (electrical connection, stability, protections, etc….)
as mentioned in the previous chapters.
When you begin working with the machine the operator must stand in
front of it facing the switch in the forward position where the handles, to lift and
move the machine from this position see
Fig.8 can press the green button
switch and the machine will start up and ready to begin cutting. The stop the
machine we will press the red button of that switch, this button has a projection
to disarm the machine without touching the green button (Fig.8) the disk stops
within the expected time interval by EC standards.
USE SAFETY GLOVES
READ INSTRUCTIONS
MANUAL
USE HELMET AND EYE AND
AUDITIVE PROTECTION
ACUSTICA
USE SAFETY BOOTS