Sima EUROTRON PLUS, Original User Manual, Page: 24 / 50

7
ENGLISH
6.4 ASEMBLING THE RULE
Loosen the steering wheel lock P, Fig.7 rule support S,
Fig.7 , freeing the piece nut which incorporates L, Fig.7
without removing completely and mount one of the two
houses of aluminium rule
R Fig. 7, according to the chosen
position is obtained with a height of side support rule under
(12 mm.) for cutting thin materials, or a position with high
side support (60 mm.) cutting thick materials (
C fig. 7 ).
Slide the rule to the desired position and secured to the
support by tightening the locking wheel mentioned above,
the rule support is in the guide that incorporates the table
E, Fig.7 , this guide in turn can be located in front, as
shipment position, or left side, removing the nuts G, Fig.7
underneath the table, then put the guide on the desire side
introducing screws in the holes of the table prepared for this
purpose and re-fix the nuts again.
6.5 MOUNTING EXTENSIBLE TABLE.
The machine is provided with an extensible table for cutting pieces of scale. Mount according to the following
image.