Bomi Furniture P/L trading as Silver Lynx ABN 99 006 489 541 11-17 Sages Road Glenroy Victoria 3046 Australia
T:+61 3 9359 4000 F:+61 3 9359 4322 E:[email protected] W:www.silverlynx.com.au
STEP 1
–
Place your bed head and side rails approximately where you would like your bed to be
set up, noting that the brackets pre-fixed to the side rails sit closer to the top edge. Connect the
side rails to the bed head by hooking the side rail brackets onto the head brackets.
STEP 2
–
Screw three button head bolts (M4) into the position shown below to connect the side
rails to the bed head and tighten (finger tight only).
STEP 3
–
Complete the above process on the other side rail.
STEP 4
–
Lift the Foot Panel into place, hooking the side rail brackets over the brackets on the
Foot Panel and secure with the remaining button head bolts (finger tight only)
STEP 5
–
Ensure that the bed is sitting square and then tighten all button head bolts using the
allen key. Once snug, tighten only with ¼ turn of the Allen Key. DO NOT USE cordless drivers or
power drills as over-tightening can cause the foot end rail to bow. After this step your bed should
look like the diagram on the next page.
STEP 1-2
