Bomi Furniture P/L trading as Silver Lynx ABN 99 006 489 541 11-17 Sages Road Glenroy Victoria 3046 Australia
T:+61 3 9359 4000 F:+61 3 9359 4322 E:[email protected] W:www.silverlynx.com.au
STEP 1
–
Position Bedhead and Side Rails approximately where your bed is to be set up. Connect
the Side Rails to the Bedhead by hooking the side rail brackets onto the head brackets.
STEP 2
–
Screw three button head bolts (M4) into the position shown below to connect the side
rails to the bed head and tighten (finger tight only).
STEP 3
–
Complete the above process on the other side rail, then repeat with the foot panel.
STEP 4
–
Ensure that the bed is sitting square and then tighten all button head bolts using the
allen key provided. Once snug, tighten only with ¼ turn of the Allen Key. DO NOT USE cordless
drivers or power drills as over-tightening can cause the foot end rail to bow.
STEP 5
–
To set up the slat and spine system, proceed to the instructions titled “Amendment to
instructions for all Silverlynx beds”.
Note the 2x 38mm screws provided in the hardware pack can
be used in this section of the assembly.
NOTES
•
Button head bolts should be regularly inspected and may need to be retightened periodically.
•
Never drag or move assembled bed as this may damage the bed
CARE & MAINTENANCE
Your Silver Lynx product is crafted with care, properly maintained, it will mature over time developing a
rich deep patina enhancing its appearance. To get the best performance from your Silver Lynx product,
please follow the simple care instructions listed below.
•
Do not use silicone based polishes/cleaners at any time.
•
Dust surfaces gently with a feather duster then wipe gently with a slightly damp cloth/chamois.
•
Do not allow liquids, damp cloths to remain in contact with lacquered surface for extended periods.
•
Never place furniture in close proximity to heating outlets.
•
Exposure to direct sunlight will cause colour fading to fabrics, leathers and timber finishes.
•
Do not allow solvents, abrasives or heated objects to come in contact with the suite.
•
Do not use cordless drivers or power drills to tighten your bed brackets, as over-tightening can cause the
foot end rail to bow.
Contact your retailer or our sales office for further information
STEP 3
STEP 4
STEP 1-2
