Silvercrest SRR 3.7 B2, Operating Instructions Manual

Page: 19 / 158

15 SRR 3.7 B2
GB
IE
5) Replace the cutting unit 2 . Refer to fi gure 1 for assistance:
–
Insert the 3 shaving heads in the recesses of the cutting
unit
2
. Ensure that the notches on the edge of the shaving
heads rest on the catches in the opening.
–
Place the round blades into the shaving heads.
–
Replace the shaving head holder, press it down a little and
slightly turn the gear wheel clockwise.
NOTE
If the holder for the shaving heads cannot be reat-
tached, it may be that the gear wheel is a little skew.
In this case, turn the gear wheel anticlockwise again
up to the stop. The holder for the shaving heads can
then be fi tted.
The cutting unit
2
is now installed again.
6) Remove loose hairs from the shaver with the brush
e
.
7) Replace the cutting unit 2 on the shaver. Ensure that it snaps
into place and is seated fi rmly.
■ Clean the housing with a moist cloth.
IB_108312_SRR3.7B2_LB3.indb 15 16.03.15 09:25