GB
│
IE
│
13
■
SSTME 600 B1
NOTE
►
In cases of lactose intolerance, we recommend you use a lactose-free milk.
Keep in mind, however, that lactose-free milk is a little sweeter.
Cleaning
DANGER! ELECTRIC SHOCK!
Before starting to clean the blender and its components:
►
Ensure that the motor is switched off and the power plug removed from the
socket.
Do not immerse the motor block
6
in water or other liquids. This could
result in you receiving a fatal electric shock and cause damage to the
appliance.
►
Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
►
Never insert your hand or fingers into the blender
3
, especially while it is
in use. The cutting blades
4
are extremely sharp!
CAUTION! PROPERTY DAMAGE!
►
Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.
Cleaning the blender
■
To prevent injuring yourself on the cutting blades
4
, clean the blender
3
only
with a long-handled washing-up brush.
■
Clean the measuring cap
1
and the lid
2
in mild soap solution. Ensure that
the rubber seal
9
is correctly fitted before using the lid
2
again.
NOTE
You can also clean the lid
2
, the measuring cap
1
and the
blender
3
with the cutting blade
4
in your dishwasher.
If possible, place all the parts in the upper basket of the dishwasher
and make sure that they are not jammed in place.
■
If you clean the appliance directly after use, you can usually achieve
sufficiently hygienic cleaning results by using the following alternatives:
Fill the blender
3
with 750 ml of water and add a couple of drops of mild
washing up liquid. Close the lid
2
and fit the blender
3
onto the motor
block
6
. Insert the mains plug into the socket and activate the pulse function
a few times so that the cutting blades
4
plough through the water at maximum
speed. Afterwards, rinse the blender
3
with plenty of clean water to remove
any washing up liquid residues.
Summary of Contents for 359632 2101
Page 3: ......
Page 61: ... 58 FR BE SSTME 600 B1 ...