■
84
│
GB
│
MT
SEM 1100 B3
3) Place the sieve holder
u
in the appliance by inserting the “INSERT” mark,
which is located next to the hot water shower
r
, into the appliance and then
turning it clockwise until the handle of the sieve holder
u
is facing the front
(“ LOCK” mark) .
4) Place a cup under the sieve holder
u
.
5) Close the steam control
7
(turn it as far as it will go in the direction of the “ - “
symbol) .
6) Switch the appliance on with the on/off switch
1
.
7) The red control lamp
t
lights up . After a short time, the pointer in the tem-
perature indicator
2
will begin to rise .
8) As soon as the green heating-up control lamp
5
lights up, press the “Espres-
so” button
3
. Allow the water to flow for about 1 minute .
NoTE
►
You may need to empty the cup in between . Interrupt the process by pressing
the "Espresso" button
3
. Empty the cup and press the "Espresso" button
3
again so that water flows through the appliance .
9) After about 1 minute, stop the pump by pressing the “Espresso” button
3
again .
10) Wait until the green heating-up control lamp
5
lights up again .
The warming-up is concluded . You can now prepare espresso .
Heating up before every use
Before you can prepare an espresso or cappuccino, the appliance must be
heated up .
1) Switch the appliance on using the on/off switch
1
. The red control lamp
t
lights up . Neither the “Espresso”
3
nor the “Steam”
4
buttons should
be pressed in . Ensure that the steam control
7
is turned towards “ - “ as far
as possible .
2) Place the sieve holder
u
in the appliance by inserting the “INSERT” mark,
which is located next to the hot water shower
r
, into the appliance and then
turning it clockwise until the handle of the sieve holder
u
is facing the front
(“ LOCK” mark) .
3) Press the “Espresso” button
3
so that the appliance draws water from
the water tank
9
. As soon as water starts exiting the openings in the sieve
holder, press the “Espresso” button
3
again to stop the pump .
4) Wait until the green heating-up control lamp
5
lights up .
5) Press the “Espresso” button
3
again and allow hot water to flow
through for 20 seconds before stopping the pump again .
The preheating process is completed . You can now make an espresso/cappuccino .
Summary of Contents for 296789
