Silvercrest 290940, Operating Instructions Manual

Page: 34 / 129

GB │ IE
│
31 ■ SSML 1000 A1
Cleaning
RISK OF ELECTRIC SHOCK!
Before starting to clean the blender and its components:
► Ensure that the motor is switched off and the power plug removed from the
socket.
Do not immerse the motor block in water or other liquids. This could
result in you receiving a fatal electric shock and cause damage to the
appliance.
► Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
► Never disassemble the cutting blades and never reach into the blender .
The cutting blades are extremely sharp!
CAUTION – PROPERTY DAMAGE!
► Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.
Cleaning the blender
■ To prevent injuring yourself on the cutting blades , clean the blender only
with a long-handled washing-up brush.
■ In a case of stubborn soiling, the blender can also be cleaned in a dish-
washer. To do this, always remove the blender , as described later.
■ Clean the lid and the measuring cap in a dishwasher or with the
normal washing up.
If you clean the blender directly after use, you can often achieve a satisfacto-
ry and hygienic level of cleaning by doing the following:
Fill the blender
with 750 ml of water and add a few drops of mild
detergent. Close the lid and fit the blender onto the motor block .
Insert the plug into a mains power socket and activate the Ice Crush/Clean
operation a few times, so that the cutting blades
churn through the water
at full speed.
Afterwards, rinse out the blender
with lots of clean water to ensure that
all detergent residues have been removed.