Silvercrest 114277, User Manual And Service Information

Page: 16 / 129

SilverCrest SSKE 300 A1
14 - English
Use
Filling the blender jug
1. Remove the lid (2) and measuring cap (1) from the blender jug (3). To do so, rotate the lid (2)
slightly anti-clockwise until the arrow on the handle (4) is aligned with the open lock symbol.
2. Add the desired ingredients to the blender jug (3). Note the minimum and maximum fill level for each
food type you wish to prepare. See the scale (5).
3. Place the lid (2) back on the blender jug (3). To do so, the lid (2) must first be rotated so that the
open lock symbol is aligned with the arrow on the handle (4). Press the lid (2) onto the blender jug
(3) and rotate the lid (2) clockwise until the closed lock symbol is aligned with the arrow on the
handle (4).
4. Place the measuring cap (1) in the opening of the lid (2) and lock the measuring cap (1) into
position. To do this, turn it in a clockwise direction.
Attaching the blender jug to the motor unit
1. If the mains plug is connected to the wall outlet, remove it from the wall outlet.
2. Place the blender jug (3) on the motor unit (6) and press the blender jug (3) down until you hear a
beep.
Warning!
Make sure the power cable is not in your working area. Otherwise you could pull it
inadvertently and knock the soupmaker over.
Switching on / selecting function
The soupmaker can only be switched on once the blender jug (3) is properly locked into
position and correctly seated on the motor unit (6).
1. Fill the blender jug (3) as described in the "Filling the blender jug" section and place it on the motor
unit (6).
2. Connect the power cable (9) plug to a live wall outlet. You will then hear a beep.
3. Press the ON/OFF button (16) on the control panel (7). You will then hear a beep, the ON/OFF
button (16) LED will light up and the LEDs for the other control panel (7) buttons will flash.
4. Press the button on the control panel (7) that corresponds with the desired function for preparing the
ingredients.
5. The LED for the selected function will then flash and all of the other LEDs will go out.