Innovative Solar Solutions | 2917 State Hwy 7, Bainbridge, N.Y. 13733 | Ph: 800.786.0329 | www.SiliconSolar.com
Genlight-12v-120LED-V1
OPERATION INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING YOUR SOLAR LIGHT. SAVE THIS MANUAL FOR FUTURE
REFERENCE.
1. PARTS CONTAINED
Please verify you have all of the following:
1) Light fixture 1pcs
2) Solar Panel 1pcs
3) Screw and drywall anchor 1sets
4) Operation Instructions 1pcs
2. INSTALLATION
This Solar light must be installed in a sunny location
where it can receive maximum sunlight at daytime. Any cover, shade, or shadowing will affect the solar panel’s ability to absorb
sunlight which will decrease the operational hours for the light.
The selected location should not be near a night-time light source such as a porch light, street light, etc., as these lights might
prevent the solar flood light from automatically turning on.
a. Mount the light fixture in your desired location
using provided U-shaped metal bracket with holes on it and screws and
anchors. This Bracket can be used as a stand and put directly on the ground or bolted through the holes to your house or
post. Adjust tilt and carefully tighten bolts where the fixture meets the bracket. Take special care not to damage the wires
connecting light head and battery box.
Turn power switch to the
ON
position the light will operate automatically.
b.
Find suitable area to place solar panel in full sunlight without shadows crossing the panel within the wire length from the panel
to the fixture. Panel can be fixed using provided pair of bracket and screws. This panel’s aluminum frame is drillable to allow
you to customize your own mounting. It is recommended to place the panel at a suitable angle towards the south for maximum
exposure. Note: Be sure to not drill through the glass that recedes into the framing of the panel.
c
. Plug in the white male adapter piece on the wire from the panel to the corresponding female adapter located beside the switch on
the fixture. The connector is water-proof.
d
. Press the metal button to turn the light ON to charge for at least 8 hrs in full sun exposure (NOTE: it can be charged if the
switch is in the ON or OFF position).
e
. After this the light will automatically turn on at dusk and turn off at dawn (light will only come on at night).
3. TROUBLESHOOTING INFORMATION
