Silicon Graphics 230, User Manual

Page: 142 / 148

126 007-4263-001
C: Regulatory Information
d. If the product does not operate normally when the operating instructions are
followed. Adjust only those controls that are covered by the operating
instructions since improper adjustment of other controls may result in damage
and will often require extensive work by a qualified technician to restore the
product to normal condition.
e. If the product has been dropped or the cabinet has been damaged
f. If the product exhibits a distinct change in performance, indicating a need for
service.
12. Replace the battery with the same type as the product's battery we recommend. Use
of another battery may present a risk of fire or explosion. Refer battery replacement
to a qualified serviceman.
13. Warning! Batteries may explode if not handled properly. Do not disassemble or
dispose of them in fire. Keep them away from children and dispose of used batteries
promptly.
14. Use only the proper type of power supply cord set (provided in your accessories
box) for this unit. It should be a detachable type: UL listed/CSA certified, type
SPT-2, rated 7A 125V minimum, VDE approved or its equivalent. Maximum length
is 15 feet (4.6 meters).
Laser compliance statement
The CD-ROM drive in this computer is a laser product. The CD-ROM drive’s
classification label (shown below) is located on the drive.
CLASS 1 LASER PRODUCT
CAUTION: INVISIBLE LASER RADIATION WHEN OPEN. AVOID EXPOSURE TO
BEAM.
APPAREIL A LASER DE CLASSE 1
ATTENTION: RADIATION DU FAISCEAU LASER INVISIBLE EN CAS
D’OUVERTURE. EVITTER TOUTE EXPOSITION AUX RAYONS.