SILENT KNIGHT IFP-2000, Installation And Operation Manual

Page: 151 / 238

Programming
151430 9-15
9.5 Point
You may need to change characteristics of individual input points (detectors and switches)
even after using JumpStart AutoProgramming. This section explains how to change options
for: type of input point; latching/non-latching status (switches); and name and zone
assignment of a point.
9.5.1 Point Programming For 5815XL Module
To program for an 5815XL Module points, follow these steps:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select for Panel Programming.
Display reads:
Initializing
Please wait . . .
3. Press to enter point menu.
4. Press the or arrows to select the desired module. Refer to Section 8.5 Quick Refer-
ence Table for available choices.
5. Press .
6. Select S for sensor for M for module.
7. Enter the number of the point you wish to edit.
8. Press .
9. Select the type of device by pressing or arrows. Refer to Table 9-2 under column
heading “Type Selection” for a list of choices.
Table 9-2 Programming Options for 5815XL Modules
Type
Selection
Function Latching Option Comments
UNUSED select for SLC points that are unused
DETECTOR
PHOTO spot photoelectric detectors
ION spot ionization detector
HEAT spot heat detector
PHOT DUCT duct photoelectric detector
Acclimate acclimate photoelectric detector
Heat HT high temperature heat detector
Photo-Heat photoelectric detector with heat sensor
Beam beam smoke detector
7
4