10 PIN
(see chart)
Starter Disable Wires
Note: Locate the vehicle START wire at the ignition switch.
Cut it and follow the instructions below.
To Vehicle Starter Wire
Valet Sw
LED
To Ignition Key Start Wire
Brown: (+) Siren
Black: Ground
White: Parking Light Relay Output
White: Parking Light Relay Power Input
15A
10A
Blue: (-) Negative Door Unlock Output
Green: (-) Negative Door Lock Output
6
7
8
9
10
5
4
3
2
1
Red: +12V Battery Power
SECURITY SYSTEM with KEYLESS ENTRY
FOR PROFESSIONAL INSTALLATION ONLY!
If you are not proficient in the installation of this product or would like a full version
of the installation manual, please visit our web site @www.magnadyne.com
Pin
Wire Color
Function
Pin
Wire Color
Function
1
Open
None
6
Black/White
(-) 200mA Dome Light Control Output*
2
Green
(-) Door Pin Input
7
Brown/Black
(-) 300mA Horn Output*
3
Blue
(-) Aux Hood/Trunk Input
8
White/Blue
(-) 200mA Channel 4 Output*
4
Violet
(+) Door Pin Input
9
Red/White
(-) 200mA Channel 3 Output*
5
Yellow
(+) Ignition Switch Input
10
Orange
(-) 500mA Ground When Armed Output*
Important Note:
The main unit should be
securely anchored to a large wire loom or
stable surface for the shock sensor and the
tilt sensor to operate properly.
*Note:
Low current outputs such as the 200mA, 300mA and 500mA (-) outputs on this unit
will only activate a relay (not supplied). They normally will not control any circuits in the vehicle
without installing a relay. Check your vehicle requirements before making any connections.
Quick Reference Install Guide