EtherHaul Operation, Administration and Maintenance Manual
Page 56
LLDP can be configured for each one of the Ethernet ports, including the radio port
(Eth0). LLDP information may be sent over VLAN or without VLAN (untagged).
This section allows configuring the following parameters:
Port – Eth0, Eth1-Eth4
Config – enabling LLDP on the port. Select
rx-tx
to enable LLDP. Note that you
may work with uni-directional LLDP by selecting
rx
or
tx
only.
VID – VLAN ID that LLDP messages will be sent on. Default is
none
(untagged).
IP Index – Lowest, Highest or IP index (1-4). The IP address the system will
respond with in the LLDP information reply. Default is
Lowest
.
7.5.2
LLDP Status
Figure 7-13 Network Page: LLDP Status
This section displays the information received from the peer device:
Note:
By default LLDP is enabled on the radio port (Eth0) and disabled on all line Ethernet
ports).
