EH-5500FD Installation Manual
Page 17
2.6
Installing the ODU with a 1ft (31cm) Antenna
2.6.1
Attaching the ODU to the Antenna
1.
Unpack the ODU, place it on a clean unobstructed work surface area, and
remove the plastic cap protecting the waveguide interface.
2.
Unpack the antenna, keeping the plastic protective cover in place, and remove
the plastic cap protecting the antenna feed.
3.
Place the antenna on top of the ODU while aligning the guiding pin on the
antenna to the guiding hole on the ODU.
4.
Gently rotate the antenna till you notice the guiding pin is in place.
5.
Turn the locking ring clock-wise, securing the antenna to the ODU.
Figure 2-1 Attaching the ODU to the Antenna
6.
Use medium-size screwdriver to tighten the locking ring is place.
7.
Flip the ODU, placing it on the antenna plastic protecting cover.
8.
Use 7mm Hex screwdriver to attach the quick release plate to the back of the
ODU using 4x 7mm screws.
9.
The arrow on the quick release plate should point to “V” on the back of the
ODU, indicating vertical polarization. You may chose Horizontal polarization if
required.
Figure 2-2 Setting ODU Polarization
