4 Structure of the temperature calibrator
SIKA Dr.Siebert & Kühn GmbH & Co.KG
Power switch
The power switch (I/O toggle switch) on the rear of the calibrator is used to switch on the power supply of the
calibrator.
Switch setting "I“ switches the power supply on, switch setting "0“ switches the power
supply off.
Directly to the right of the power switch is a warning symbol.
It means: "Caution, general point of hazard“
Two examples for type label
4.6 Components of the calibrator bottom
The power socket with integrated safety fuses are arranged in the bottom of the calibrator. For this reason, a
power cable with an angled inlet connector for non-heating apparatus must be used.
4.7 Warnings used
Since there are high temperatures on the top of the calibrator directly in front of the block bore, the following
warning has been attached to this area:
Directly to the right of the power switch is the warning symbol displayed.
It means: "Caution, general point of hazard“. It advises you to read the corresponding chapters
(e.g. chapter 2, chapter 4) of the operating instructions.
