Symbol Description
Indication symbols
Transmission in incremental mode
Transmission in staircase mode
Transmission in simple ramp mode
Transmission in cyclic ramp mode
Transmission in synthesiser mode
Transmission in% of Full Scale mode (% FS)
Transmission in valve test mode
Item already selected
Measurement smoothing is active
The Tare function is on
Setting to scale is on
Pulse transmission
Data recording (the value to the right indicates the number of values logged)
1.4
Safety
1.4.1
Compliance with safety standards
The unit is built and tested in accordance with European standard EN 61010-1: safety rules
for electronic measuring equipment.
These user instructions contain information and warning notices which must be respected by
the user for protection against danger from electric currents, ensuring correct operation of
the unit and protection against any false step that could damage the unit or make it unsafe to
use.
The unit may, when necessary, be subjected to temperatures of between -10°C and +55°C
without prejudicing safety.
1.4.2
Instructions
The unit is designed to be used in complete safety if the instructions given in the accompany-
ing documents are followed. Any use apart from those defined, may prejudice the safety of
the operator and is therefore dangerous and forbidden.
1.4.3
Making measurements
Measuring wires and leads must be in good condition and must be replaced if their insulation
appears defective (insulation cut, burned, etc.).
When the unit is connected to the measurement circuit, the terminals may be dangerous. Al-
so, never place your hands near a terminal, whether in use or not. This advice also applies to
the battery charger sockets and the USB link connected directly or indirectly to the terminals
of the unit. Any work on these circuits must be carried out with the unit disconnected from
any other external circuit.
