3
PANEL DESCRIPTIONS
Front / Rear Panel
1. LCD
- Indicate "IR Signal Strength"
- Indicate "IR Frequency"
- Indicate "IR Jack Power Voltage"
- Indicate "IR Jack Pin Configuration (Power/ Signal/ Ground)"
2. Push Button: Clean the measurement
3. Battery holder: Place an alkaline 9V transistor battery here
4. Mini-USB : Feed Power / Firmware update
5. 3.5mm Jack: measure IR Jack Power Voltage and Pin Configuration
6. IR Sensor: measure IR Strength and IR Frequency
7. 3.5mm Jack: Extend IR Sensor, to measure IR Strength and IR Frequency
8. Power Switch
