SIIG AV-GM01Q3-S1DS, Manual, Page: 8 / 16

6
HARDWARE INSTALLATION
1. Connect your video sources to the input connectors.
2. Connect your HDMI, or DVI enabled monitors into the device's DVI-D output port.
3. Power up the AV-GM01Q3-S1DS.
4. Use IR to select the input, setup the output resolution, and adjust your video format
DEFAULT SETTING
1. Power up the AV-GM01Q3-S1DS.
2. To reset AV-GM01Q3-S1DS back to the factory default values, pull up-and-down the DIP switch 1
& 2 from OFF to ON to complete the process. You NEED to pull back the DIP switch back to OFF
in order to get AV-GM01Q3-S1DS work normally.
NOTICE
1. As the video formats evolves and expands, AV-GM01Q3-S1DS is firmware upgradable for this
fashion.
2. PIP and PAP only support digital and analog display or dual display for single input.