SIIG AV-GM01Q3-S1A, Manual, Page: 8 / 17

6
HARDWARE INSTALLATION
1. Connect your video sources to the input connectors.
2. Connect your VGA, HDMI, or DVI enabled monitors into the device's DVI-I output port.
3. Power up the AV-GM01Q3-S1A.
4. Use IR to select the input, setup the output resolution, and adjust your video format
DEFAULT SETTING
1. Power up the AV-GM01Q3-S1A.
2. To reset AV-GM01Q3-S1A back to the factory default values, pull up-and-down the DIP switch 1 &
2 from OFF to ON to complete the process. You NEED to pull back the DIP switch back to OFF in
order to get AV-GM01Q3-S1A work normally.
NOTICE
1. As the video formats evolves and expands, AV-GM01Q3-S1A is firmware upgradable for this
fashion.
2. PIP and PAP only support digital and analog display or dual display for single input.
3. Analog stereo audio can merely support 2-channel audio. This version does NOT support
8-channel analog audio applications.
4. S/PDIF audio input can support 2 out of 8-channel audio input.
5. S/PDIF supports only 48kHz audio sample rate. Other than this rate, the input digital audio
should be adjusted to 48kHz in order to get audio signal correctly sent.