Mounting
Instruction Manual VisGuard 2
14162E/2
25
4
Mounting
CAUTION!
Danger of the photometer falling onto the road if improperly mounted.
The following requirements must be met when fastening the instruments in place:
When fastening the photometer, screws with a diameter of at least
M8
must be used.
The material quality of the screws used must correspond to the local mounting and in-
stallation guidelines.
4.1
General information on mounting the VisGuard 2
Figure 8: Installation position
The VisGuard 2 must not be installed in the direct flow area of the ventilation system as
different wind speeds and sandblasting effects can cause measuring faults.
A vertical installation position is recommended. Increased soiling of the optics can be
expected at deviations of more than 20°.